If you haven’t set up a Riak Node and started it, please visit Running A Cluster first.
To try this flavor of Riak, a working installation of Python is
required, with Python 2.7 preferred. One of the Python package managers,
pip, is also required to install the client
You may install
setuptools on OS X through MacPorts by running
port install py-distribute.
pip are included in the
Homebrew formula for Python on OS X as well. Just run
First, you must install some packages needed by the Riak Python client:
python-dev— Header files and a static library for Python
libffi-dev— Foreign function interface library
libssl-dev— libssl and libcrypto development libraries
Ubuntu (12.04 & 14.04)
sudo apt-get install python-dev libffi-dev libssl-dev
The easiest way to install the client is with
Either of the commands below will ensure that the client and all its
dependencies are installed and on the load path. Depending on where your
Python libraries are held, these may require
pip install riak
Now, let’s build the client.
python setup.py install
Connecting to Riak
Now, let’s start the Python REPL and get set up. Enter the following into the Python REPL:
If you are using a single local Riak node, use the following to create a new client instance:
myClient = riak.RiakClient(pb_port=8087, protocol='pbc')
# Because the Python client uses the Protocol Buffers interface by
# default, the following will work the same:
myClient = riak.RiakClient(pb_port=8087)
If you set up a local Riak cluster using the [[five-minute install]] method, use this code snippet instead:
myClient = riak.RiakClient(pb_port=10017, protocol='pbc')
We are now ready to start interacting with Riak.